Control Knob

thingiverse

This part serves as a replacement for a handle that was originally attached to a snow blower. Over time, the handle had become severely worn due to years of use and needed to be replaced entirely. The new part was specifically designed to match the original control knobs on the snow blower precisely. Print Settings Printer: Monoprice Rafts: Yes Supports: Irrelevant Resolution: 0.3 Infill: 50% Notes: The print shown in the image turned out fairly well without supports, but it's evident that this is a case where the limits are being pushed. If I were to print this part again, I would likely incorporate a support to aid in forming the knob top.