
Constant - steadfast supporter of books
thingiverse
Meet Constant. He's holding on that books for you. His proud job: constantly clamp those books together so they don't fall.. With his arms outstretched, he clamps your favorite books. One more book? No problem, slide a new book in the middle and he stretches his arms even further. He likes books with a height between 19 and 23 cm (7.5" - 9"). For a good grip, place the highest books near his hands. He doesn't like anything higher because then he can no longer peek over the books. He likes to be seen, so don't stuff him away on a bookshelf (min. 11"/28cm), but give him a place to show off his powers. By your side at your favorite reading spot will be a nice place… Tense as he must be for his task, there is still some flexibility: You can e.g. stretch (not shorten!) his arms a bit making room for even more books. Scale only in the longitudinal direction and all applicable parts equally, the Body Arm Bar and both Left and Right Arm! Shorten or lengthen his legs for higher or lower books. Scale again only in the longitudinal direction!. (When scaling too much, it is possible that his pants are falling down a bit or his socks are showing up..)
With this file you will be able to print Constant - steadfast supporter of books with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Constant - steadfast supporter of books.