Console1 Rack Mount Brackets for ZAOR MIZA X2

thingiverse

I was looking for a solution to rackmount Softube's console 1 on my Zaor Miza X2 desk. More specifically to the centre rack however there are no brackets for this use case on the market. I decided to design my own, and after a lot of trial and error a managed to design these 4 brackets that allowed me to rack mount the device as I wanted to. In order to use these after you print them, you will need to remove the 4 outer screws from the grey metallic frame and loosen the 2 middle ones so that the brackets can fit in the space under the grey metallic frame and the black panel. The bottom metallic part of the device is not required. I would also suggest that you replace the outer screws with longer ones and add washers at the back. I hope this helps!