Connector mashup: Mil-spec M38999 and Molex 0/062 contacts

thingiverse

Connector Mashup: Mil-Spec M38999 and Molex 0/062 Contacts Inspired by the mil-spec 38999 series of connectors, this mashup combines a shell size 15 M38999 connector plug and receptacle with Molex 0.062 contacts used in Thingiverse's 2755931 project. To print these connectors, first print the test block and fit pin connectors into the holes. Choose the hole size that fits snugly around the pin, but is not too loose to allow the end of the pin to wiggle significantly. Loose pins will not seat properly in the socket contacts and can become damaged. The knurled connector ring is secured by a split washer, which screws onto the ring. A cable clamp is also included with this design. OpenSCAD code is not currently available due to its messy and work-in-progress state. Contact P/N: These connectors are designed for use with Molex contacts, specifically: Female contact: Molex P/N 02-06-1103 (used in the bulkhead receptacle) Male contact: Molex P/N 02-06-2103 (used in the plug (cable))