Connector for Nidec Servo Corporation KH42 & KH56 series

thingiverse

This is to replace the connector has female 11 pins that is used to plug to the stepper motor pruduced by Nidec Servo Corporation KH42 and KH56 series. The stepper motor only use 6 pins, so I only make 6 holes for 6 pins to make it stronger in 3d print. Printing: - kh42 series: 0.4mm line width, enable print thin wall. No support is needed, zero hole/horizontal expansion. Print from the flat surface on the top. - kh56 series: 0.275 line width, enable print thin wall. No support is needed, zero hole/horizontal expansion. After printing, you might need to sanding a little bit if the connector is too tight to fit to the stepper motor.