Confidently Walking Scootaloo

prusaprinters

<p>Scootaloo, just walking around.<br/> (My Little Pony fanart.)</p> <p>Based on the drawing by xbi: <a href="https://www.deviantart.com/xbi/art/Everfree-Forest-Cmc-Scootaloo-Sweetie-Belle-Apple-828884645">https://www.deviantart.com/xbi/art/Everfree-Forest-Cmc-Scootaloo-Sweetie-Belle-Apple-828884645</a></p> <h3>Print instructions</h3><p>The model comes in two variants: one with hair, one one without.<br/> If you print the one without hair, you can for example glue on yarn as hair.</p> <p><em>I have not tested the version without hair!</em></p> <p><strong>IMPORTANT</strong><br/> The center of gravity of this model is very close to the left side of the front leg.<br/> Depending on your slicer settings, your finished print might <strong>not be able to stand!</strong><br/> To ensure that your print can stand:</p> <ul> <li>print the tail with higher infill (this is already done in the gcode and 3mf), and</li> <li>ensure good bed adhesion, so the hooves end up flat. (I did not have an issue with this, though.)</li> </ul> <p>The version without mane and tail may not be able to stand at all.<br/> However, you can glue it down or add a base if you want to.</p>