Cone Remix to DPs Cupcake Design

prusaprinters

Printed with MK3S+/Generic hi viz green PETG/0.2mm QUALITY/organic supports Remixed using TinkerCADThis was my first remix and I am new to 3D modeling, so feedback/suggestions welcome. Thanks!**UPDATE: Initial tests did not yield intended result. I used only a 15% infill and the float tends to sit horizontal on top of the water - not terrible in terms of visibility, but not what I was hoping to see. Since the top is hollow and the cone bottom is not, I think a greater infill density (>20%) might shift the weight toward the bottom of the float and correct it's floating position while still remaining buoyant. I'll test that next.