Cone Joint Stuffer

thingiverse

Works with cone joint papers. I used a piece of filament to connect the pouring cone by sticking it through and melting the ends. This method is more novelty than functional, but it does work. To successfully use this setup, you need to grind your material very small to powder and add it slowly so that it doesn't clog the cone. To get the cone to slide up and down the shaft properly, I melted the cone holder's end and pinched it a little so it grabs the barbs on the shaft. I then melted the end of the shaft and pressed it into the base. Print Settings: Printer: M3D Rafts: It doesn't matter. Supports: It doesn't matter. Notes: I broke the pieces apart and printed them individually, with some requiring supports and others not needing any at all. I printed the cone on its side.