Condition marker clip/holder for monster standees in Gloomhaven/Frosthaven

thingiverse

While being thrilled by standee holders like me and my group always found condition markers clumsy to attach and remove from the base, especially in crowded rooms. So I designed this clip where original condition markers from the game can be placed into and easily attached to the top of monster standees without lifting them from the board. Meant to be printed with a 0.4 mm nozzle, since the rim has a width of 0.8 mm. I had to print them in 101 % size so that condition markers from the game fit perfectly. But I think that's the fault of my printer, so I left the slot in the models at a size of 14 x 14 mm as they theoretically should be. If you have the same problem, try scaling them up a bit in your slicer. With the original design, I had severe problems with adhesion, maybe only 50 % of the models stuck to the heatbed. Unfortunately Cura doesn't support inner brims yet (see https://github.com/Ultimaker/Cura/issues/2853), but an outer brim is hard to remove, especially between the pins of the clip. So I designed a model with a custom inner brim that can easily be removed with some cuts using small pliers. Another problem with dial standee bases is their limited HP they can represent. Even the 18 HP of the model mentioned above do not suffice for some monsters in higher levels and are still clumsy to adjust, especially if printed with an imprecise printer like mine. The 10-markers can be used to "extend" the dial by attaching additional 10s of HP to the top of the standee. Update: Added a clip that can be used to put a character token on a monster, e.g. required for Scoundrel's Long Con bottom ability and others (no spoiler).