Concrete cast survey marker

grabcad

This 3D Printed mold designed to cast another material, and in my case I use ultra hard cement, link below. Be sure to use a "release agent" to allow this form to separate from the cement once hardened. If you don't have a release agent, you may be able to try WD-40. Since this is a cast, the text is mirror reverse. You will need to print 1 lid, 3 mold wall sides, and 3 locking mechanism / clips. Everything snaps together, spray release agent, pour your concrete, wait to dry. Disassemble. I have reused these numerous times. Check the laws in your state - in my state you cannot make up your own property marker (you must be licensed) but you can point to an official existing marker. In my case a pin was buried in the ground and difficult to find. once found I simply placed this on top of the survey marker pin, such that this would not interfere with lawn mowing. Link: https://www.homedepot.com/p/Rapid-Set-55-lbs-Mortar-Mix-04010055/202188453Motor Mix: https://www.homedepot.com/p/Rapid-Set-55-lbs-Mortar-Mix-04010055/202188453