CONCEPT CAR

cults3d

Scale 1 measures 18 cm in length and 17 cm in width with a height of 10.5 cm. Assembly order is cyanolite bonding. First, glue the left flank to the trunk. Next, stick the right side to the trunk. Then, attach both the left and right sides along with the trunk to the floor using glue. Following that, apply glue to the flying plate on the inside of the assembly. Stick it firmly against the rear trunk between the left and right flanks. Glue the bonnet in place with the radiator grille attached. Secure the hood and grill to the floor using glue. Attach the gear lever to the floor. Next, glue the steering wheel to its support. Finally, seat the seats inside with a 1 mm wedge against both sides of each seat. Stick by breeze on the inside. Glue left and right steps onto the floor against both sides. Secure wheels onto both left and right sides, either wheel or wheel1. Just attach the rim solely to wheel1. Glue the soft top to the rear trunk. Stick pots, headlights, and logo into place. Directions for injection include: flat: steering wheel plate on the car flat: car radiator grille flat: logo on the car flat: by breeze because flat: two car tail lights flat: car floor flat: steering wheel on the car flat: left flank because, do in symmetry flat: four car rims in profile: left wing because, do in symmetry in profile: two car seats in profile: inside the car profile: bonnet of the car in profile: soft top of the car in profile: car boot standing: gear lever on the car standing: two headlight cars standing: two pot cars standing: four wheels or wheel1 Good route... be careful, do not show this to children, it may make your printer bleed.