Concept Board Game Organizer and Playable Box

prusaprinters

This is a little box I made for Concept to make the game easier to play and put all the little bits in an organized container that is easy to pass around. The one problem is that the question mark standee is so tall that it creates a tiny bit of lid lift on the box. If you don't print the lid it's a little less, but it's honestly not very bad. I prefer having a lid to make sure nothing moves around when I store vertically. The lid may be a little tricky to print, but don't be too intimidated by it. No supports, first layer between .12 and .25 mm. I prefer the look of .2 but all of them look nice.Happy Gaming!If you like these check out my Etsy shop Taylor Jane Design Co.