Concept 2 - PM5 phone holder

thingiverse

A simplified remix of this phone holder for a Concept 2 erg PM5 - https://www.thingiverse.com/thing:4276626 - that fits larger phones than the stock accessory and places it below the PM5 unit. You can add a rubber band around the horizontal strut if your phone seems not secure enough in the cradle. The cutout in the front is for ease of swiping up when the phone is landscape mode, and the channels in the bottom of the cradle are for volume and/or power buttons to not accidentally get pressed. I opted to design and print it as one piece with a lot of supports but it would definitely print faster and cleaner and use less filament as two pieces. Also, removing the supports can be tricky so I may revise it at some point unless someone remixes it before.