Concentric Arcs Shelf Bracket 200mm x 200mm
myminifactory
Shelf bracket - 200mm x 200mm (just under 8" x 8") legs, 25mm (1") wide. Great for a 230mm (9") deep shelf. Could be scaled down, but smaller screws may need to be used. Printed a 100%, the screw holes are perfect for standard drywall screws. Bracket pictured was printed with 20% infill and a .16mm layer height. Excellent print on a Creality CR-6 SE in PLA without support. Note that there is one short section that prints with a 67.5° overhang. Support may be needed if your printer can't handle that angle. Inside corner screw holes are not accessible straight on- it is recommended to predrill the hole and use a long screwdriver to drive the screw. Printed in PLA at 20% infill, the single bracket held well stacked with 16 pounds (7.25 kg) of weight. Two or more brackets and an attached shelf should increase stabilization. Your results may vary.
With this file you will be able to print Concentric Arcs Shelf Bracket 200mm x 200mm with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Concentric Arcs Shelf Bracket 200mm x 200mm.