Component Tester Housing

thingiverse

This is just another neat little box to house my cheap Chinese origin components tester. Before printing, please look at the tester unit in the photos to make sure it matches yours. The board has hole spacings of approximately 68mm x 71mm, the smaller dimension running in the same direction as the screen width. It needs four screws to hold the unit in place. The screen cover is a really neat fit on my unit so may not quite work with yours due to manufacturing tolerances. However, the box can still be used without it. There is a flexible grip in the box to prevent the battery from moving around too much. I printed this in PLA and the battery grip works fine as it isn't too highly stressed. PETG would possibly be a better filament to use. For this application it doesn't matter too much provide some care is taken. I have glued some anti-slip matting onto the base to stop the unit moving about on my desk when inserting components. The four screws I used were recycled from old solar lights.