Companion Cube Multiple Parts for Printing

thingiverse

The initial printed model had minimal sagging due to overhang, but this issue increased at larger scales. To overcome this, I decided to slice the part into three sections and assemble them later using acetone. When printing, remember that the files are scaled quite large; adjust the size of your cube accordingly by scaling all three parts simultaneously. Additionally, if you typically print with a high number of solid exterior layers, lower the count to avoid an almost solid cube. For reference, I usually use five exterior layers for structural components and forgot to reduce the quantity. You can opt to print parts A and B as either solid or 'hollow' (with an 8cm plug removed from the center). Print one of A, one of B, and two of C to complete your project.