Compact Makita TS100 Soldering station (UPDATE V2)

prusaprinters

!UPDATED Version 2!Holder V2: Long arm removed from holder and increased hole size for filament hinge. The arm is not necessary and only gets caught in the housing the hole was a little to tight.Mainbody V2: The removal of the long arm gives more space for the magnet which catches the the drawer when it's pulled out at the back----------------------------------------------------------------------------------------------The holding arm has three different locking positions. This is realized with magnets. Also the drawer is hold in three positions by magnets. It has enough space to store a tip, a soldering sponge (inside the drawer insert), the allen key and about 80cm of cable. The hinge of the holder is made with a small piece of filament.You will need the following additional components:QuantityDescription1 xMakita 644808-8 18V original battery contact plate1 xM12 washer (19mm OD | 13.3mm ID)9 xcylindrical magnets (6mm OD | 5mm DP)4 xM3 threaded inserts (used the ones from CNCKitchen)2 xM3x25mm screws2 xM3x10mm screws25mm1,75mm filamentapprox. 80cmtwo-wire cable (e.g. 22AWG is rated for 5A | Pmax. 65W => ~18V => 3,6A) 1xCoaxial power connector Type A (5.5 mm OD | 2.5 mm ID)