Compact Hemera mounts for 40mm blower fan, inductive sensor, and HyperCube bracket (no supports needed!)

thingiverse

Update 01/22/20: Changed M3 screws to note that 6mm screws should be used to secure the mount to the Hemera for a tight fit rather than 10mm screws. Update 01/13/20: A dual 50mm version has been uploaded [here](https://www.thingiverse.com/thing:4101390) and an endoscope/12mm probe mount is available [here](https://www.thingiverse.com/thing:4101407). The same probe mount design was kept, so any probe mount should work on either fan mount. Update 12/17/19: I am not satisfied with the part cooling using the 40mm fan, so a new mount is being designed to hold two 50mm blower fans. So far, much better results have been obtained with a prototype of this design. In the meantime, it's recommended to use a different blower fan mount if your print head has sufficient clearance. This set of mounts was designed for mounting the Hemera to my HyperCube build. The blower fan and probe mounts should be compatible with any other printer if you'd like to mix it with another carriage design. Included parts are: * 12mm probe mount. * 18mm probe mount, e.g. the EZABL. * Filament sensor mount, with holes for optionally attaching an drag chain. Also included is text for multi-material printing. * 40mm print cooling fan mount. This part sits very close to the heat block, so printing in ASA/ABS is recommended! PETG also probably works, but it hasn't been tested yet. * Carriage mount for the original HyperCube. It's possible to figure out EVO mounting holes if there's interest. M3 screws needed are: 6mm x4 (probe to fan mount and carriage mount to Hemera), 8mm x 4 (blower), 25mm x2 (filament sensor), 10mm x4 (carriage mount to carriage) Make sure to have `Z_SAFE_HOMING` (or your firmware's equivalent) in Marlin set to true! The probe sits farther in front of the nozzle than most mounts. My probe offset is X0Y14Z0.