Community Print 3D Print of ED209 from Robocop

myminifactory

Reduced to 80%. Stacked 16 parts onto a single plate, which was enjoyable. Had to manually add supports to the legs, as they were flimsy. A piece of filament caught fire on both ends and stuck to the support and bed simultaneously, resulting in an instant cross-brace. The canopy latching frame-bar needed to be chamfered back to 45 degrees to accommodate the canopy's attachment. I printed the canopy without a raft or supports, which was a bold move. The painting turned out well, but after reading an article on finishing techniques, I realized I could have done it professionally next time. I wish I had used weathering wash to highlight the detailed panels and seams, but I thought it might also get into the layer lines.