Comgrow Z1 Air Assist Nozzle

prusaprinters

<p>This replaces the original shroud on the Comgrow Z1, and is the same height as the one used for 10 watt Z1. The top plate mounts with the same screws that hold the original shroud, and the nozzle section attaches with 6x2mm magnets. This way it is easy to remove and clean the lens, and will also just get bumped off if it collides with something. And if the worst happens, and it gets melted, easy to print a replacement. It is setup to use a dual output aquarium pump.&nbsp;<br><br>Note that the left air line connection will bump into the laser frame if auto homing is used, but it will just askew a bit, and can be tappe back into place. I have stopped using autohome, because it is rather useless on these machines anyway.</p><p>I have included a simple clip to hold the air lines up against the laser body. It clips into the fins on the laser. It isn't the best, but gets the job done.</p>