Collet flashlight holder for bicycle

thingiverse

Added clamp for thin handlebar diameter 22mm. Added collet for flashlight with a diameter up to 27mm. 0. For torch diameter 20...25mm (ideal for Convoy S2+ or similar) 1. Print the bolt and nut vertically, so the thread is better printed. 2. A clamp is best printed flat, allowing layers to work along tearing forces - that's why they're made in different parts. 3. The collet must be printed from soft plastic (FLEX, TPU, RUBBER, or SBS). 4. You can print the collet from hard plastic, but it will be difficult to install - unless you cut the ring, then you might manage. 5. Also needed are 4 screws, 2x15mm in length. 6. And some nail for the hinge axis; trim and hammer it into place, securing with hot-melt glue from the ends. Great result overall - everyone's approved it!