Cold frame (greenhouse) for .5" PVC

thingiverse

A remix of https://www.thingiverse.com/thing:3425340 That plan used .5" conduit but I had .5" PVC readily available. The outside diameter was larger so I printed the clips at 130% and everything else at 134%. The files in this remix have already been scaled up. I really did not understand how to properly use the type 4 connector from the original plan. I feel like it needed at least one additional screw hole (which I just drilled into the ones I had already printed). I also didn't use the type two connectors. I instead created a "T" connector and a type one "double" connector (I made type one connector two sided... which I assume was the intended use for the type 4 connector....) Summary of parts: Type One Connector: To support the upper poles (but not the top center) of the greenhouse. If chaining multiple greenhouses together, you will use less of these. Type Three Connector: For all four corners, and the top middle support pole. Type T Connector: When chaining multiple greenhouses together, use this for the bottom connectors and the top middle support. Type One "Double" Connector: When chaining multiple greenhouses together, use for the upper bars (but not the center top one). Clips: To hold the plastic Ventilation Holder: To hold an extra PVC pipe for to allow for a vent