Coinbox ship - top level of forward internal storage compartment for coins

grabcad

A component of a multi-part design project which I intended to be my entry to the Thingiversity Science Challenge: Make It Float, of 2015, which was about designing a boat that can carry coins or keep them afloat.Unfortunately, due to a lot of complexity creep, I missed the deadline for the challenge and eventually put the project on ice entirely and indefinitely. However, I've since decided to upload what parts of the ship I did complete to grabCAD and try and work on what's left to finish more from time to time so that hopefully, eventually, I'll complete the entire ship, including all internal and external parts.This particular component is part of one of the internal structures of the ship which support coins and keep them from freely moving about inside the hull. It's the top level of a three levels high stacked structure which resides inside the front half of the hull, more near amidship than the prow. The prow section houses a different multi-level structure.The design is more artistic than practical or precisely engineered. I designed the internal structures of the ship primarily with the intent of fitting as many coins as possible into each section of the hull and didn't give as much as I maybe should have to ship ballast, centre of gravity and balancing. And I didn't perform any FEA or FEM on the model. Manufacture would probably require 3D printing.