coiling unit

cults3d

This is a tool to make air coils of up to 60mm outer diameter. It can be configured to be used by both, left and right handed people. Two 4mm screwholes give you the opportunity to bolt it down to your dinner table while you are awaiting the food to be rolled on :) If you put short pieces of wire in the channels of the tooling halves when you do the first layer you can twist and tighten up the finished coil to keep it in shape. I think it´s not really necessary to count the windings as long as one puts a bit of effort in the process and fills up the groove every time to the same level. In order to be modifyable I´ve attached the halves in stp-format. parts list: 1x supply_bracket 1x lock_left 1x lock_right 1x handle 1x crankshaft 1x tower 2x coiling tool 1x guiding_bracket 2x bolt M5x60 inner hex 2x nut M5 2x ball bearing 16003 (id17 od35 t8)