Coffee Dispenser for Nescafé glass bottle

thingiverse

Tired of dirty coffee spoons in the coffee jar? Tired of caffeine abstinence causing your hand to shake and coffee spilling everywhere but into your coffee mug? Worry no more! The coffee dispenser is here to save the day. Simply place it over your cup and turn halfway for one teaspoon of coffee (5ml). Turn again if you want more, easy! No spare parts are required. Everything can be printed, except the Nescafe glass container. The Nescafé container this print is designed for has an inner diameter of 46.6mm. Check out the photos. Print instructions: Print two DosierFasteners. One of each of the other STL files. Use supports on top and bottom. I printed using a 0.2mm layer height on a Prusa i3 MK2S. Assembly instructions: Watch the video: https://www.youtube.com/watch?v=tqcsF8uFTTg Important: Note that the hole in the top part and the hole in the limiter should be on opposite sides. Otherwise, you might just pour the whole bottle directly into your coffee cup. Adjust their relative position to each other by changing the pin's position in the top part. The limiter always needs to be screwed on as tight as possible without breaking the print. You may want to try screwing the screws into the doser before assembling it. It goes smoother the second time you screw and makes for easier assembly. You might also want to remove the foam from inside the Nescafé lid, make some cuts, and put it into the top part. This will make the top part more airtight and fit nicer to the Nescafé bottle. This is optional, though. Usage instructions: Position the Nescafé bottle over your mug. Turn the bottom part halfway and coffee should be dosed. Check out other useful prints at www.youtube.com/ttgeek. I've been working on this design for three days now, so I'd appreciate a few coins if you find it helpful. Thanks!