Coffee Caddy

prusaprinters

<p>My local Philz Coffee ran out of the paper carrying trays, so I designed this reusable coffee caddy/carrier to use instead. It also incorporates hooks, so that I can hang a bag with food items and carry them in one hand.</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Craftbot Flow IDEX</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>200</p></div> <p><strong>Infill:</strong></p> <p>10%</p> <p><strong>Filament:</strong></p> Craftbot PLA <p>White</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Tray - 0.3mm layers, 150% extrusion width, 10% infill, 3 vertical shells, 6 bottom, 7 top layers, but anything that leads to sufficient strength to hold full cups of coffee</p> Handle - 0.2mm layers, 100% extrusion width, 10% infill, 4 vertical shells, 7 bottom, 8 top layers <p>Tray was ~330g, handle ~90g</p> <h3>Post-Printing</h3> <p><strong>Assembly</strong></p> <p>Additional hardware required:</p> <p>M3 brass inserts like these: <a href="https://www.mcmaster.com/97171A310/">https://www.mcmaster.com/97171A310/</a></p> <p>M3 x 12 socket head screws like these: <a href="https://www.mcmaster.com/91292A114/">https://www.mcmaster.com/91292A114/</a></p> <p>Insert M3 brass heat-set inserts (2) in to holes on INSIDE faces of the handle using a soldering iron or similar (I used a Modifi3d Pro).</p> <p>Insert handle in to holes in tray until both sides are flush with the bottom of the tray.</p> <p>Fasten using two M3 x 12mm screws. Access is a little tricky, as the screws are hidden and threaded from the inside (as I didn't want the screw heads exposed on the outside face of the tray - yes that's a little crazy for a tray). Finger tighten as much as you can and then finish using the short end of a L-shaped hex wrench.</p> </div></p></p> Category: Food & Drink