Cobbllebot Vertical Mounted dual extruder

thingiverse

This is a remake of my initial cobblebot dual extruder designs. They are based on my original design, so the front fan mount will work seamlessly with the previous ones. Every component uses an M3 screw and built-in supports are included. While supports aren't necessary, adding in brim will be beneficial. Version 3A features a 6mm hole for zip ties and wire management, and is designed to be mounted on top - however, this isn't required. It's possible to use two version 3B in place of the V3A. Both require a 15-20mm M3 screw to mount version 3C. Version 3C, with its oval-shaped hole on the bottom half, is used for leveling the dual extruder heads. For version 3D, there are supports outlined in blue that need to be cut out for the Z-level sensor nut and washer. Versions V3C/V3D have no built-in supports. BLTouch support has been added, but generated support will be needed. Fat Version 3D supports an 18mm sensor. Dual version 3C features two adjustment mounting holes with a switch for ease of access.