Cobb Vanth Belt Buckle from the Mandalorian Season 2

thingiverse

This is Cobb Vanth's belt buckle from The Mandalorian Season 2. This was printed on a CR10-S5 with a 0.8 mm nozzle in white MatterHackers Build Series PETG at 100% infill, and with supports. It seems pretty strong. I am not worried about the post on the back breaking off any time soon. You can print it with a smaller nozzle for less filling and sanding but I would suggest doing it at 100% infill for strength. I personally print all my costume and prop parts in PETG for its heat tolerance and relative ease of printing. The belt is made from [this belt blank from amazon](https://www.amazon.com/dp/B07VHRPGNK/ref=cm_sw_em_r_mt_dp_yAP7FbHNGCAA8?_encoding=UTF8&psc=1). The belt is 1-3/4 inches wide, 50 inches long, and 4.2mm thick (i.e. 9-10oz leather). As far as I can tell, 1-3/4 inches wide is correct from my calculations doing some dimensional analysis based on the sizes of some known parts. The hole in the leather belt that the post of the belt buckle goes through is about 4.5mm in diameter. Make sure that the hole in the leather is just big enough to allow the post on the back to go through it but small enough that there is some resistance when pulling it back out. I believe this model is relatively accurate but if you can point me to reference that shows that changes need to be made, I would probably be open to do it.