CO2 Cradle

prusaprinters

<p>Update 220109: On request, added a five-bulb variant with provision for a 6.5mm allen key (CO2 x5 w-6.5.stl). This is based on the low-poly version I've been experimenting with.</p><p>A relatively straight forward cradle to hold three, four, five, or six 12g CO2 bulbs, as used for gas powered Airsoft or Gel Blasters, in addition to a 6mm allen key. Keeps your bulbs together and relatively secure when transporting or on the field.</p><p>Pictured is the 5-bulb variant.</p><p><i>NB STL file sizes are a bit large due to excessive geometry in the curves. I may revisit these later to reduce the complexity as it is almost entirely superfluous, depending upon popularity and feedback.</i></p><p>&nbsp;</p><p>This is a relatively simple design in terms of printer capability, so there's no specific requirements. I personally used three walls to give a little better layer adhesion.</p><p>Designed to be printed as oriented without any special additions, but could easily be stood on one of the ends if a brim is used for stability and supports at least considered for the allen key holder/locator (though they may not be required).</p><p>Can be mirrored without issue if you want the allen key holder on the opposite side.</p>