CO2 bottle under shelf mount

thingiverse

This is an easy-to-use under shelf storage holder for CO2 bottles. This design relies on 8mm rods for stability. I utilized 8mm aluminum rods (hollow) that I cut to a length of 27cm. Scale up the model if you use material known to shrink (I used ABS and printed at ≥ 101%). If your printer prints accurately, you should be fine or just need a few turns with a drill bit. Rod mounts are designed with an 8.1mm diameter, which worked well for me. It's recommended not to use PLA. Print Settings Printer: X-Machines Lorei Rafts: No Supports: Yes Resolution: 200 microns Infill: 25% Notes: Material: ABS (PLA not advised) Print the designs with the flat side facing downwards on the print bed and the mount pointing upwards. Post-Printing Assembly Give the 8mm rods a slight chamfer and gently push/twist the rods until they're fully seated in the mounts.