CNC ER11 wrench shorty - upgraded

thingiverse

I imported it to Tinkercad, cut out a 50mm block, rejoined the halves. Made a shorty - don't need insane torque to tighten an ER11, if the tool was metal I could understand it being so long for Abom torque . Kudo's to Saur0n for his awesome CNC ER11 wrench - upgraded design. For mine, scaled 101% in X and Y, Z at 100% (for a little tolerance) printed 4 shells, 4 top, 4 bottom, and 40% cubic infill to make sure it has good 3 dimensional strength. I found the open end to be just a tiny bit too tight - even after upscaling... measured and the notch on the long part is 14mm, made a new one with 14mm space, the enclosed side scaled up 101% fits like a glove