CNC Dremel endstop mounts

thingiverse

Some basic mounts for the endstops printed with PETG, these work perfectly on my machine after combining two designs. I am currently utilizing Nikoderms Y mounts (https://www.thingiverse.com/thing:3004773) and Golo's Z and X mounts (https://www.thingiverse.com/thing:3747551). The X carriage mount holds the micro end stops for both right and left movement. There is an end stop mount for the front and rear, which are connected to the right side Y mounts. A wire connection to the rear Y is quite tight if you use a spade connector; I had to cut off some excess plastic. If you solder it, this should be easy. The right Y carriage bracket mounts using the two center holes (M3). The center support is slightly longer to help push the bracket down when tightening. Three small holes are available for M2 screws, allowing you to choose the length needed and adjust it to trigger the endstop. I'm using a washer and nut to prevent the screw from being pushed into the hole.