Clutch Gear Holder 1983 Honda Shadow 750

grabcad

I needed to remove the clutch gear from my 1983 Honda Shadow. Rather than buy the tool, I made this model to fit in between the posts that hold the timing coils and the clutch gear drive.In the service manual this is in section 7-23 on page 112.I recommend removing both pulse generators and printing two of these. I tried with one and it exploded when I tried removing the bolt. It's torqued to 80-100Nm (58-72 ft-lb). So I printed two and used 60% infill and it work great.The fit might be a little tight. I just used a hammer and tapped them in.