CloverMINT (Reprap Clover reboot)

thingiverse

CloverMINT is a revolutionary re-design of the original Clover, featuring an advanced two-piece frame, a cutting-edge effector with a rock-solid connector for seamless toolhead interchangeability, and state-of-the-art wire routing, all nestled within a completely enclosed base that eliminates loose electronics. Additionally, I've upgraded to Greg Wades' renowned bowden extruder, known for its unparalleled reliability and ultra-high resolution. By leveraging the Legacy and Plus variants of EffectorV3, this printer can effortlessly integrate with modules from both the legacy Clover and CloverPlus by pbmax. Specs: * Printable radius: approximately 130mm in diameter * Printable height: up to 180mm high * Printing speed: reaches a maximum of 100 mm/s * Movement speed: achieves speeds of up to 150 mm/s Assembly: The comprehensive list of required parts and tools can be found here. Detailed assembly instructions and videos will be available soon. The included extruder is a custom-made remix of the bowden Wade's extruder, designed by buba. Print Settings: * Printer: RigidBot * Rafts: No * Supports: Yes * Resolution: 0.2 or lower * Infill: 20% or higher Notes: * Only supports are necessary on the bottom frame piece, which should be in contact with the bed. * Rods may require a raft to adhere properly to the build plate. * Feet should be printed using TPU/Ninjaflex for optimal performance.