Clothes peg minimal for quick print.

thingiverse

I saw the lack of easy-to-print clothes pegs on Thingiverse. The one I did see was an old-fashioned wooden design. I wanted something straightforward and quick to print, so I created this minimalist model of a peg. It's a simple setup, consisting of just the essential elements needed for a functional clothes peg. I printed them in PLA on my Dremel 3D printer, producing four pegs within twenty-four minutes using minimal support material (just ten percent honeycomb infill). Despite being left outside in the harsh Australian sunlight for several hours, there's been no noticeable melting or bending due to heat stress. **Printer Settings** * Printer: My trusty Dremel Idea Builder * Rafts: Not used * Supports: No additional support needed * Resolution: Set to Low for efficient printing * Infill: Just ten percent hexagonal infill, allowing for good airflow and rapid printing.