Clips for 10mm wide LED strips

thingiverse

I am building an IKEA enclosure and up to the part where I add LED lights but the clips I found on thingiverse were not wide enough for the light strip set I purchased so I built clips suitable for this purpose and this 10mm wide light strip set (Monster Illumination Sound Light Set - 65 inch long). This prints without support and if you have decent bed adhesion, you wont need a brim either. (I printed on PEI with no brim). Hopefully this helps somneone else fit this type of light set - Added Edge Clip with 1 screw hole and slightly raised other side so it clamps shut from the single screw - Screws I used were SAE #6 x 1/2 inch (It is a tight fit even with these which is what I wanted (Wanted it to be pressing the plastic clip fully) so screwing in the screw to prep the hole prior is recommended)