Clip on Tool Holder - MPMD

thingiverse

I upgraded my original tool holder design by adding a clip that allows me to securely attach it to the side of the printer. In order to get the tool holder to fit snugly on the build plate, I had to remove the slot for the plastic scraper, but since I rarely used it, this adjustment didn't cause any inconvenience. To ensure a proper fit, I upped the original clip size by approximately 103%, making it necessary to test print the first couple of mm before printing the entire design. This will give you an opportunity to verify that it fits perfectly for your printer. I personally printed mine upside down without any support, but if you're concerned about the overhang in the glue stick cutout, you can opt to print right side up with supports enabled.