Clip-on Seat Post Rear Light

thingiverse

I'm making a special clip-on holder for LED strips that fit perfectly on 1-inch diameter bicycle seat posts. This nifty device can hold up to three sections of 60 LEDs per meter wide LED strips, which are just 12MM thick. If you want a more permanent installation, I've also created this template as a drill guide so you can embed the LED strip inside the post itself. It's a bit trickier, but it'll keep your lights safe from damage. To add some color to your setup, use a red gel filter with white LED strips. If you want to buy everything you need for this project, I've got you covered - just hit me up! I'm selling power banks, wires, and all the necessary bits to get you going. The power bank I'm using is an 18650 USB rechargeable unit that packs a 3400 mAh punch from a Panasonic cell. These cells are also used in Teslas, so you know they're top-notch. And the best part? Most of my upcoming bike light designs will run off these very same power banks. If you want to customize this design or try something entirely different, feel free to edit it on 3D Orchard: https://3dorchard.com/app/single/5881976400b5ca0c9dad1bfe/591e6c2cc4b4a10d124ba3e3