Clip on Paintbrush holder

thingiverse

So I have these little rice pudding jars I have been using to put brush cleaner in, for when I am working on miniatures, figures and dioramas. They're an odd size, but perfect for putting a small amount of cleaning solution in for deep cleaning my somewhat expensive detail brushes. However, usually, when you need to do this deep clean thing, you have to leave the brushes in the fluid for half an hour or so. I didn't have a good clip on brush holder, and I'm not a 3d modeler, but I found this clip that looked like it would work, and a stand alone single brush holder that also might work. So I combined the two using chitubox, and exported it as a single file, then dropped it into cura to run on my FDM prints. As I use these and figure them out, I'll refine the settings, design and sizes of the parts so that they'll fit what I need. Maybe someone else needs something similar? It seemed like a useful thing, so I'm sharing it here.