Clip for Maxbotix LV-EZ0 ultrasonic rangefinder

thingiverse

This is a little clip to let you hang the MaxBotix LV-EZ0 ultrasonic sensor on something. It has a little bump aligned with one of the holes on the board, which should loosely hold it in, but won't stop you from sliding it out. Prints fine without supports, though a brim might be advisable, as there isn't a lot of area adhering to the print surface. I've included the Fusion 360 archive. There are several user parameters you can adjust, but the main one would be Clipslot_depth, which will adjust how far the clip is from the body. UPDATE: I am finding that these do not seem to print well with more than one at once; the clips seem to break off during the print. I don't know if it's the translations of the extruder head slightly vibrating the print bed, or what, but you may have best luck printing one at a time.