Clip for glass plate of 4mm for Anet A6 A8

thingiverse

I was having trouble finding a suitable clip for my mirror bed that's just 4mm thick. To solve this problem, I designed and printed clips using Tinkercad to hold my bed in place. Fortunately, they work flawlessly in my setup. To ensure an extra-tight grip, I standardized the gap between the clips at 6.9mm for all models. I currently use eight v2 clips to secure my bed, which provides excellent stability. For optimal results, it's recommended to print these clips standing up, but lying them down also works effectively. Below are the three versions of the clips I've designed: - side_clip_6_9_mm.stl: This is the largest clip I created first; while sturdy, it's a bit cumbersome. - Smaller_clip_7mm_1.stl: This design features edges on the sides and is smaller than the previous model, but still slightly too large for my probe. It remains quite sturdy, however. - Smaller_clip_7mm_v2.stl: The smallest clip I designed is only 1mm high, which allows my probe to hover just above it. While not as sturdy as the other two designs, I'm hoping they will hold up well over time.