Cleat Mount for Wall Control Pegboard

thingiverse

These are components that will allow you to easily modify new and existing designs for mounting on Wall Control pegboards. Cleats print in two parts and may or may not be glued together on their flat face. If using with a "loose" cleat or void they should be glued. Voids may be subtracted from the mounting face of a model to make it compatible with the cleat. Just make sure that the void is flush with the back and bottom of the model to allow the cleat to mate with the void. A "loose" cleat/void will has generous tolerances that allow easy placement and removal of a part to/from that cleat. You can always use glue to make a loose fit permanent if you like. A "tight" /cleat/void has a friction fit that is more or less permanent, You will be able to get it off with a bit of work, but its not meant to be taken apart once it mates with a cleat. If your model has insufficient "meat" to subtract from, merge a "receiver" to your model for compatibility with the cleat. This design is just a combination of two really well executed ideas from @3DBK and @Abrak. I'll upload models that use this system as I make them. You should too!