Clean Dishes, Dishes Dirty, dishwasher sliding sign

thingiverse

This is a sliding Clean/Dirty Dishes sign for your dishwasher. Instructions: *If you've been 3D printing for a while, you're probably okay without these instructions for changing colors to make "Clean" green, "Dirty" red, "Dishes" black, and the body silver. However, read on if in doubt and feel free to comment if you need clarification/help. 1.Start "Clean_Dirty_Sign_Parta01.STL" with green filament or whatever color you want for "Clean". 2.As soon as you start to see the sidewall edges form for the word "clean" on the left, which indicates that the word clean's last layer is finished, then change the color to red for the word "Dirty". **Change From Green to Red at or between 2.6mm to 2.8mm** 3.When the red word Dirty is complete, you will see the sidewall edges form around the word "Dirty", and that tells you it's time to change to Silver to complete the print. **Change from Red to Silver at or between 3.3mm to 3.5mm** 4.In the slicer orient "Clean_Dirty_Sign_Partb01.STL" with the word "Dishes" at the bottom by rotating on the X axis 180 degrees. *Optionally, (advanced) print with Dishes facing upwards with support material as originally oriented - adjust color change as needed. 5.Start printing the "Clean_Dirty_Sign_Partb01.STL" with the color Silver and change to Black after about 3 to 4 layers at 0.2 layer resolution or 5-6 layers at 0.15 resolution so that the word "Dishes" is Black and finish the part in Black. **Change from Silver to Black at or between 1.4mm and 1.6mm** Post Printing: 1.Glue three 10mmx1.5mm magnets in the three recessed holes on the back. Cover with masking tape and trim so you don't scratch your dishwasher with the magnets. 10mm with 1mm thickness would be fine also - like these: https://www.amazon.com/MosShop-Refrigerator-Magnets-50pcs-10mmX1mm/dp/B07176K33G/ref=sr_1_9?ie=UTF8&qid=1524023465&sr=8-9&keywords=10mm+magnets 2.Break a magnet in half (or optionally use whole magnet) and paste the parts on the inside of part B (the "Dishes" part) next to each side wall as depicted in the picture of the Black part. Before you glue, check your polarity with the main part for magnetic attraction to the "Clean" and "Dirty" sides of the part A. You can snap the two parts together to check this. 3.Snap Part A to Part B and place it on your dishwasher. If the magnets are causing repulsion such that the slide does not snap to clean and dirty then reorient the magnets on Part B.