Clapper Slate

prusaprinters

<p>Clapper Slate (aka Clapperboard) is a single print, with no assembly required.</p> <p>I have been looking for a clapper slate for a while and could not find a authentic looking one, so I decided to create one base on a typical cliche design.</p> <p>The print needs support which can be easily removed by pliers. To set the joint free, insert a cutter/knife into the gap and twist to break the support apart. Model paint is recommended but a permanent black marker will do just fine. White board marker works for writing on the surface and should be erasable.</p> <p>Default size is 13cm by 11cm.</p> <p>Clapper Slate XL size is 22cm by 18cm.</p> <h3>Print instructions</h3><p>Printer:<br/> FlashForge</p> <p>Rafts:<br/> No</p> <p>Supports:<br/> Yes</p> <p>Resolution:<br/> 0.3mm (That's what I used)</p> <p>Infill:<br/> Doesn't Matter</p> <p>Notes:<br/> Requires Support. Higher print quality recommended for the letters to show better. Minimum tolerance is 0.3mm.</p> <p>Post-Printing<br/> Remove Support<br/> Remove support by pulling with pliers.</p> <p>Break free the joint<br/> Insert a cutter/knife between gap, twist until a snap for the joint to break free</p> <p>Colouring<br/> Use model paint or just permanent marker to paint the board and the letters and you're done!</p>