Clapper Slate

pinshape

Clapper Slate Summary Clapper Slate is an authentic print that requires no assembly. I created it after searching for a genuine-looking clapper slate and not finding one, so I decided to design it based on a typical classic look. The print needs support, which can be easily removed using pliers. To free the joint, insert a cutter/knife into the gap and twist until the support breaks apart. Model paint is recommended for coloring, but a permanent black marker will do just fine. A white board marker works well for writing on the surface and should be erasable. The default size of this clapper slate is 13cm by 11cm. Printing Settings Printer: FlashForge Rafts: No Supports: Yes Resolution: 0.3mm (I used this resolution) Infill: It Doesn't Matter Post-Printing Notes Requires Support Higher print quality recommended for better letter visibility Minimum tolerance is 0.3mm Remove Support Remove the support by pulling with a piler Break free the joint Insert a cutter/knife between the gap and twist until it snaps to break the joint free Colouring Use model paint or just a permanent marker to paint the board and letters, and you're done!