Clamps

thingiverse

The Hand clamp is depicted in its assembled state with the following components:-\nA 6mm x 120mm stud, one 6mm Nyloc nut, a single 6mm coupler (or wingnut), two 4mm Rivetnuts and a 1 x 4mm x 16mm bolt. Also visible is a 6mm x 90mm bolt substituting for the stud with an elastic band holding it in place. The maximum diameter that can fit within the jaws is just over 40mm.\nA smaller clamp also utilizes 6mm x 120mm studs, four 6mm half nuts, and 6mm couplers. The depth of its jaw measures approximately 32mm.\nThe third clamp employs 8mm x 450mm studs, four 8mm half nuts, and 8mm couplers. Its jaw depth is roughly 35mm.