Clamp wall, Parametric

prusaprinters

3D printed parametric wall clamp for pipe, Default diameter 32mmManufacturing procedure:Material: PETG (possible alternatives ABS, ASA, PC, PA11), not recommended PLA3D Printer: FDM 3D printer, average print time 30 – 60 minutes, depending on parametersSlicer settings: 4 perimeters, 0.2mm layer height, print in the position where the clamp is lying on the print bed to increase the strength and adhesion to the print bedPost processing instructions: Clean the stringing, check clearance of the screwAssembly instructions: Use the screw (default diameter 4mm) to mount to the wall, insert pipeFollowing parameters can be adjusted using Autodesk Fusion 360:PipeParameter - Enter value from 20mm to 40mm, for higher or lower values the right geometry might not be generated.ClampThickness - Enter value from 12mm aboveClamping Angle - Enter value from 60 to 150 degrees.ScrewDiameter – Enter value according to the used screw with 0.1-0.3mm more for toleranceScrewHeadDiameter – Enter value according to the used screw with 0.5- 1mm more for toleranceDistanceFromWall - Distance of Pipe diameter from the wall