Clamp on Pool Tray

prusaprinters

Secures to the top tube/frame of an Intex pool. No tools or fasteners needed. The tray slides on to the frame and the support bracket slide on to the frame underneath the tray. Note that these are a fairly tight fit so that the tray and support do not slide off. My initial design had a pin to hold the support in place, but found the support and tray held pretty well without it. I may look at putting the pin or some other retention/locking feature back in for future revisions. The frame is secured to the pool by a clamp with two screws. The threads are a fairly tight fit. This is my first go at modeling threads, so they could be better. However, I've found that tight fit on the screws helps prevent them from backing out. I ran the screws through the frame and backed them out before attaching it to the pool. Printed in PETG to handle the heat & solar load. I wouldn't recommend PLA for this application.