Civil Warrior CW-01 General Grant Super Mode Shoulder Gun Mount

prusaprinters

A bracket designed to allow Civil Warrior's CW-01 General Grant to mount his gun over his shoulder while in Super/Combined Mode. The gun fits in firmly similar to how it would into his hand, while the bracket grips over a small horizontal section inside his backpack. Can be left in place even when transformed back into a trailer without getting in the way of anything. Note: This has been designed to mount on his right-hand side, as that's what I prefer. You will need to mirror it for the left. Update 04/05/20 I've uploaded two new designs: a stylised version of the static mount, and a two-part articulated mount. The articulated variant (A-1 and A-2) has a ratcheted joint which allows for three "clicks" of rotation, with the most elevated position being roughly in line with as far as General Grant can look upwards. Update 05/05/20 Updated the articulated A-1 file to tighten up the ratchet and add extra points of grip. Since the grip ring is fairly narrow and the teeth are small, I increased the width of the ring slightly, added two extra fixed mounting points, and doubled up on the teeth. No change in articulation range or number of steps, and compatible with the original A-2. Update 03/06/20 I've finished designing a new articulated mount in the form of C-1 and C-2. These are NOT compatible with the A mount, but offer a few advantages: they joining pin is now 4mm across (was 2.8mm), a set of three teeth now lock the two parts together (assemble/disassemble at 90° rotation), and both pieces can be printed without supports (makes the joint cleaner, though at the cost of being 1.2mm wider). The actual ratchet mechanism is unchanged from variant A. Update 05/06/20 I've tightened up the joint in the C variant and made some slight changes to the model decoration. The end result is that it should print very slightly faster (C-1 is about 1 minute faster) and hold position much better. Note that it will be VERY stiff initially, but will wear to a more reasonable (but still usable) point fairly rapidly. It should still be perfectly compatible with the old C variant pieces, so if you want to save time and filament than only one of them would need reprinting to get most of the benefit (though I would recommend both). Print Settings Printer Brand: Creality Printer: Ender 2 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.2mm Infill: 20% Cubic Filament: 3DFillies PLA+ Transparent Blue Notes: Print in the supplied orientation. No supports are required unless your printer is particularly terrible at overhangs (there are some 45° overhangs). This piece will be slightly visible when in Super/Combined Mode, so I would recommend using a suitable colour - blue, black, red, or silver. Designed for 0.2mm layers but should work with others. As mentioned, mirror on X or Y to switch shoulder. Update 04/05/20 The articulated variant A-1 requires supports to print. Otherwise, these new versions have the same printing requirements as previous. Update 03/06/20 Articulated variant C has the same print requirements as fixed unit. You can, of course, rotate C-1 such that it still uses supports if you want. Category: Toy & Game Accessories