CityStar platform

thingiverse

The concept behind this achievement is to acknowledge your success, so occasionally stop by and remember what you've accomplished. You can also use it as an opportunity to showcase your achievements, but that's not the primary goal. This glass figurine serves as a trophy, a small reward from our community when you reach a higher level of education. Components: * 3 high-intensity white 5mm LEDs * 3 resistors with 150 Ohms/0.25W resistance * 1 Micro USB B female PCB connector * Wires * Some hot glue The LED holes are 6mm wide on the top platform and 8mm wide on the bottom, allowing for a perfect fit of the leads and plastic casing. Installing the micro USB connector requires some care, but you can use small pliers to push it into place. Alternatively, you can solder the connector to the wires after installation. Print Settings: * Printer: German RepRap Neo * Rafts: Not necessary * Supports: Yes * Resolution: 0.2mm * Infill: 30% * Notes: I used brim settings to prevent warping on my printbed.